Reliance-controls Pro/Tran Q Series User Manual

INSTALLATION AND OPERATING INSTRUCTIONS 0 Q-Series MANUAL TRANSFER SWITCHES FROM

Certain models have color-coded wire leads instead of a terminal block. Connect the wire leads to the remote power inlet box using the same color key

Operating Instructions Using your Reliance Transfer Switch and Your Portable Generator Warning: Do not operate a generator in an enclosed area

10 Transferring from Generator Power to Utility Power 1. Return all circuit selector switches to the LINE position. 2. Follow the procedures in the

Transfer Switch Parts List 3 Description Part# Description Part# Circuit breaker, 15 A S.P. 8491 Power inlet, 20 A L1420F Circuit breaker, 20 A S

Reliance Controls Corporation is pleased that you have made the decision to purchase this product. We have been manufacturing innovative, quality el

Reliance Controls Corporation / 2001 Young Court / Racine, Wl 53404 Phone: (800) 634-6155 Fax: (26

Residential Wattage Requirements Appliance Running Watts Add watts for starting Furnace blower, gas or fuel 1/8 hp 300 500 1/8 hp 500 750 1

Warnings • Cautions 1 Warning: Improper installation of this transfer switch could cause damage or personal injury by electrocution or fire. Insta

Reliance Installation and Operating Instructions Key Components of the Reliance Transfer Switch 2 Handle tie Circuit breakers. Each transfe

Electronic wattmeter (suffix -AE and -CE models). Two sets of LED readouts (a long and a short) appear on the face of the meter. The left set applie

to bend the flexible conduit beyond its structural capabilities. Wiring the Reliance Transfer Switch to the Load Center Determine which circuits

breaker compartment cover, unscrew the terminal screw in the breaker to be removed, removed the wire, tilt the top of the circuit breaker towards you

Installing 240-volt Circuits Any two adjacent circuit selector switches may be used for a double-pole 240-volt circuit. Use a handl

3. Loosen the screws that secure each wire to each circuit breaker. Disconnect the wires from the circuit breakers. 4. Feed the two red wires in Ste